Built-in pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame. Compatible with OZO Touring and Enduro kits. Very simple installation. Three-way JST connector. Pedal sensor installation instructions
These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.
12x magnets ring for pedelec sensor. Drive side and opposite side available.
This extension cable has a 3-way JST connector for pedal sensor or accelerator. With switch 3-Position. Available in 3 lengths :30 cm 50 cm 100 cm
©2018 OZO électric