Magnetic contact to activate the brake cut on your 15A or 22A system while maintaining your original hydraulic brakes. Also compatible with all bikes equipped with a 2-way Julet connector.
This ebike accelerator is thumb operated. This model is mixed, that is to say that you can install it on the right of your handlebar as on the left. Ideal for off-road because you will have a better grip of your handlebar in the technical passages. Supplied with 3-way JST connector.
This brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles It is quick to install on the brake handle or caliper. Connectors: Julet 2 pins for touring kit controller and enduro and VAE trade.
This USB charger allows to recharge a phone, a gps thanks to the battery of the bicycle. Compatible with the jst output of the 15A controller of the 250W OZO kit and the 22A controller of the 750W-900W enduro kit. 44x21x11mm Accepts an input voltage from 7 to 60V DC and delivers a constant voltage of 5V with a max load current of 1A.
This ebike accelerator is thumb operated. This model is mixed, that is to say that you can install it on the right of your handlebar as on the left. Ideal for off-road because you will have a better grip of your handlebar in the technical passages. Supplied with 3-way JST connector.
Contact brake handle compatible with the 22A OZO controller You can buy a right handle or a left or the pair. Two colors available: Gray or black.
Stand for installation of a display in the center of the handlebars. The compatible displays are: - DISPLAY TFT 965 - DISPLAY TFT 850 - DISPLAY LCD 3
Half handle type accelerator. Ideal for long rides and people used to motorcycle. Compatible with all our kits.
Original handlebar support for Bafang displays:- DIsplay LCD C800- DISPLAY LCD 965- DISPLAY TFT 850Used to replace the original support if it is broken.
These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.
Y cable wire to plug 2 sensors on one entry of your Bafang motor BBS01 BBS02 BBSHD maxdrive or any system using Julet connector 3 pins. With this cable you can plug one or two gear sensors, and plug two brake sensors on your Bafang central motor.
This case will allow you to aesthetically fix your 15A 250W controller on the frame of your bike. The box is installed on the vertical frame tube using two clamps. Your frame tube should have a maximum diameter of 36mm.
Extension cable Julet for bafang display 5 pins or OZO display 30cm length
12x magnets ring for pedelec sensor. Drive side and opposite side available.
©2018 OZO électric