€25.00
(tax incl.)
ANDERSON to JULET Z209AG adapter. Allows to install ebikes lights by connecting in series between batetry and controller
Chargement des images...
Wiring to connect a switch between the lamp and the controller
Wiring to connect a switch between the lamp and the controller powered via the Cycle Analyst jack.
€20.00
(tax incl.)
Reference:
000186
You may also like
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
€25.00
(tax incl.)
Cable harness to connect your display to your OZO wheel motor.
€20.00
(tax incl.)
Motor cable extender 45cm and 1m
Extension for motor cable with 3x 2.00mm2 cables for the phases and 5x 0.22mm2 cables for the HALL sensors.
The extensions are supplied with Anderson PP30 connectors for the phases...
€5.00
(tax incl.)
2-way extension cable for temperature and ON/OFF switch's controller of 25A & 35A.
Available in 4 lengths
20cm
50cm
100cm
140cm
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€25.00
(tax incl.)
This adapter allows to wire headlight or battery gauge in parallel of the battery power line
€8.00
(tax incl.)
This extension cable has a 3-way JST connector for pedal sensor or accelerator. With switch 3-Position. Available in 3 lengths :
30 cm
50 cm
100 cm
Customers who bought this product also bought:
€10.00
(tax incl.)
Multifunction switch with two positions.
It can be used as an ON/OFF switch for your lighting or for your OZO controller.
Supplied with 2-pin JST connector.
Leave a review