Filters
Accessories for cycle analyst
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
€15.00
(tax incl.)
Support for potentiometer to screw on the back of the V2 or V3 analyst cycle
€20.00
(tax incl.)
This cable allows to update your cycle analyst with the last software version and also to read and set all datas on your computer.
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€30.00
(tax incl.)
Universal shunt 1mOhm for V2 and V3 analyst cycles. You can use the analyst cycle on any controller, solar panel, or charger. Supports a direct current of 50A and a max current of 100A
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side of your bike.
€40.00
(tax incl.)
This potentiometer is perfectly compatible with the V3 analyst cycle. It will allow you to limit the power or speed of your engine while driving without having to enter the setup.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€50.00
(tax incl.)
Gift voucher worth 50 € to 200 €
Valid for 1 year on all products on the site
€18.00
(tax incl.)
Specific three-position switch for the V3 analyst cycle.
This switch integrates resistors on each mode and will allow you to define three different assistance algorithms by activating the "auxiliary" setup of your V3...
€129.00
(tax incl.)
This Analogger can be plugged on Jack connector of your CA V2 or V3 to record all datas of your system and travel ( for GPS integrated version).
The accessories for cycle analyst will allow you to use all the functionalities of the cycle analyst. You can retrieve and analyze the data of your output with your electric kit. You can also change its modes of use, adapt it to any setting and much more
