€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Magnet for speed sensor
The speed sensor magnet is the essential accessory for operating your speed sensor. Simply attached to a spoke of your wheel, it passes in front of the sensor at each rotation to transmit an accurate measurement of your speed and distance travelled to your on-board computer. Universal and easy to install, it is the ideal part to complete your system or replace a lost magnet.
€4.50
(tax incl.)
Reference:
000102
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Customers who bought this product also bought:
€10.00
(tax incl.)
Multifunction interruptor with 2 positions
It can be used as a switch for your lighting or your OZO controller
Delivered with 2 JST ways connector
€9.90
(tax incl.)
This spacer allows you to adapt a speed sensor to a wider frame (fatbike type).
It is sold with 4 plastic clamps.
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€79.00
(tax incl.)
Offset Narrow Wide chainring for Bafang BBSHD crankset engine. CNC machined in Alu 7075, which gives them great longevity and a weight gain of 400g compared to the original steel tabletop.
The torque gain is...
€2.50
(tax incl.)
The temperature sensor for CA V3 is the essential safety accessory to protect your engine against overheating. Connected directly to your Cycle Analyst V3 on-board computer, it measures the internal temperature of...
€45.00
(tax incl.)
Freewheel 9 speed 11 to 34 teeth standard compatible Shimano
staging: 11,13,15,17,19,21,24,28,34
Weight: 580g
Leave a review