€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Cycle analsyt V3 PAS sensor
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side of your bike.
€39.00
(tax incl.)
Reference:
000095
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Dimension of sensor :
Customers who bought this product also bought:
€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
€4.00
(tax incl.)
The XLR male plug is the ideal power connector to equip or repair the cable of your electric bike battery charger. Very common on 24V, 36V or 48V charging systems (generally in 3-pin version), it offers an...
€49.00
(tax incl.)
Special MTB plate in 32, 34, 36 or 38 teeth NARROW WIDE black anti-derailment.
This plate machined in Aluminum 7075 will be the best choice for mountain biking with your Bafang crankset motor.
Perfectly adaptable on...
€20.00
(tax incl.)
This 33cm brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles
It is quick to install on the brake handle or caliper....
€19.00
(tax incl.)
The 1.20 m backpack battery extension is the ideal accessory for installing your battery in a backpack to lighten the frame or equip an all-suspension mountain bike. Its generous length gives you complete freedom of...
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame.
Torque arm 1 2D plane
€30.00
(tax incl.)
Universal shunt 1mOhm for V2 and V3 analyst cycles. You can use the analyst cycle on any controller, solar panel, or charger. Supports a direct current of 50A and a max current of 100A
Leave a review