€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Support bracket for CA
The CA (Cycle Analyst) bracket is the ideal accessory to install your on-board computer directly in the center of your cockpit. By attaching the Cycle Analyst to the stem, you free up space on your handlebars while benefiting from optimal and ergonomic visibility over all your assistance and battery data while riding.
€16.00
(tax incl.)
Reference:
000098
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Customers who bought this product also bought:
€10.00
(tax incl.)
This brake extension cable has a JST connector available in :
- 30cm
- 50cm
€10.00
(tax incl.)
These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.
€1.50
(tax incl.)
The Anderson box holding clip is the essential accessory to secure your electrical connections against road bumps and vibrations. It firmly locks two Powerpole connectors together, preventing any accidental...
€3.50
(tax incl.)
The Anderson Case Sealing Cap effectively protects your connectors from water, dust and debris when your battery is disconnected. This is the essential accessory to protect your electrical contacts against oxidation...
€62.90
(tax incl.)
The slightly baloon profile of the Hans Dampf makes it a good choice for tough mountain bikes and mountain bikes and for those who want maximum comfort.
Extremely stable on the sides, resists punctures thanks to the...
€2.50
(tax incl.)
The temperature sensor for CA V3 is the essential safety accessory to protect your engine against overheating. Connected directly to your Cycle Analyst V3 on-board computer, it measures the internal temperature of...
€90.00
(tax incl.)
The OZO 15A Controller, equipped with Field-Oriented Control (FOC) technology, ensures optimal performance for OZO Brushless motors. Its IP6-rated tropicalization and waterproof connectors provide exceptional...
Leave a review