€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Speed sensor for cycle analyst
The speed sensor for Cycle Analyst is the ideal accessory to accurately measure your actual speed and distance traveled on your electric bike. Connected directly to your on-board computer, this sensor works with a magnet attached to the wheel to provide reliable data in real time, even when the motor is freewheeling. It is the essential tool for accurate performance monitoring and optimal management of your battery life.
€16.00
(tax incl.)
Reference:
001816
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Customers who bought this product also bought:
€25.00
(tax incl.)
This adapter allows to wire headlight or battery gauge in parallel of the battery power line
Limited time offer
€99.00
(tax incl.)
€129.00
OZO offers you to choose from three models of displays with Bafang protocol UART 5.2 and 5.8 with cylindric green 5 pins female connector.
Compatible with all bbs series central motor from Bafang and some OZO hub...
€9.99
(tax incl.)
Precision tool to expose a wheel or replace a broken spoke.
€15.00
(tax incl.)
Three-position switch to attach to the handlebar of your bike and connect to the dedicated connector of the OZO dual sensorless / sensored controller in order to benefit from three different power modes which are...
€2.50
(tax incl.)
The temperature sensor for CA V3 is the essential safety accessory to protect your engine against overheating. Connected directly to your Cycle Analyst V3 on-board computer, it measures the internal temperature of...
€46.90
(tax incl.)
This bag is easy to install on any bike. You can get it to travel on normal bicycle but also to install your ebike battery.
You can add one neiman to get ON/OFF function on your ebike
€90.00
(tax incl.)
The OZO 15A Controller, equipped with Field-Oriented Control (FOC) technology, ensures optimal performance for OZO Brushless motors. Its IP6-rated tropicalization and waterproof connectors provide exceptional...
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
Leave a review