€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Programming cable for cycle analyst
This cable allows to update your cycle analyst with the last software version and also to read and set all datas on your computer.
€20.00
(tax incl.)
Reference:
000096
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Customers who bought this product also bought:
€18.00
(tax incl.)
Specific three-position switch for the V3 analyst cycle.
This switch integrates resistors on each mode and will allow you to define three different assistance algorithms by activating the "auxiliary" setup of your V3...
€39.90
(tax incl.)
Miche Supertype chainrings to the 4x104 MTB standard perfectly compatible with the associated 4-hole adapter.
High quality chainrings machined in Aluminum 7075 to ensure good longevity against the torque of Bafang...
€30.00
(tax incl.)
Universal shunt 1mOhm for V2 and V3 analyst cycles. You can use the analyst cycle on any controller, solar panel, or charger. Supports a direct current of 50A and a max current of 100A
€79.00
(tax incl.)
OZO offers you to choose from three models of displays with Bafang protocol UART 5.2 and 5.8 with cylindric green 5 pins female connector.
Compatible with all bbs series central motor from Bafang and some OZO hub...
€0.00
(tax incl.)
Optimized mapping by OZO. The Original Bafang mapping is appropriate for city bike with 44T chainring and can occurs some disappointments for specific profile as MTB, cargo or road bicycle.
Since 2013, OZO has...
€20.00
(tax incl.)
Motor cable extender 45cm and 1m
Extension for motor cable with 3x 2.00mm2 cables for the phases and 5x 0.22mm2 cables for the HALL sensors.
The extensions are supplied with Anderson PP30 connectors for the phases...
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame.
Torque arm 1 2D plane
Leave a review