Chargement des images...
TORQUE ARM Collar tab
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame.
Torque arm 1 2D plane
€12.00
(tax incl.)
Reference:
000013
You may also like
Limited special offer
Limited special offer
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
Limited special offer
€19.00
(tax incl.)
€21.50
The Torque Arm allows to limit the stress on the bike frame, at the level of the wheel fixing beaks, to avoid any deformation.
It is highly recommended for kits over 400W.
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
Torque arm 1 plane
Customers who bought this product also bought:
€20.00
(tax incl.)
Pedal sensor in housing for OZO controller 25A and 35A.
For cases with external bearings such as Shimano hollowtech, choose the "transmission side".
Very simple installation.
3-way JST male connector.
Installation...
€59.00
(tax incl.)
These modules allow for the parallel connection of batteries to increase their autonomy.
Compatible only with generic batteries of the same voltage, although the battery capacity may vary.
The small module is limited...
€19.00
(tax incl.)
Pedal sensor compatible with the generic 250W controller for the repair of electric bikes.
2 models available: Integrated 12 magnets or V7 6 magnets
The V7 comes with a 6-magnet magnetic washer.
Cable length of 60...
€14.90
(tax incl.)
Speed sensor for Bafang central motor BBS01 BBS02 BBSHD
Speedo replacement part
€17.90
(tax incl.)
Same positioning of the bracket on the handlebar or stem. Our bottle cage adapter is attached with two clamps. Either on the outside of the ahead spacer (mostly sport, trekking and MTBs) or directly on the standard...
€25.00
(tax incl.)
Replacement cable for the gourd or bottle battery V1.
Lenght : 20cm
€6.50
(tax incl.)
Nylon Battery strap to secure your heavy battery frame and avoid to impact M5 screw on your frame.
Nylon and velcro strap can fit on any frame battery up to 1000Wh
Dimensions : 60cm X 5cm
Leave a review