Chargement des images...
Torque arm M16
You may also like
Limited special offer
Limited special offer
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
Limited special offer
€19.00
(tax incl.)
€21.50
The Torque Arm allows to limit the stress on the bike frame, at the level of the wheel fixing beaks, to avoid any deformation.
It is highly recommended for kits over 400W.
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€21.00
(tax incl.)
This hexagonal base offers angular freedom that allows it to adapt to all frame geometries.
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on...
Customers who bought this product also bought:
€1.45
(tax incl.)
We can cut spokes at your convenience.
Conventional rolled 18/8 stainless steel spoke with constant wire diameter from the head to the thread.
13G spokes (2,3mm diameter)
€79.00
(tax incl.)
OZO offers you to choose from three models of displays with Bafang protocol UART 5.2 and 5.8 with cylindric green 5 pins female connector.
Compatible with all bbs series central motor from Bafang and some OZO hub...
€3.00
(tax incl.)
The female jack socket is the ideal chassis connector to integrate a clean and discreet connection port on your controller, battery or console housing. Combined with a male jack, it allows you to easily plug and...
€20.00
(tax incl.)
Universal thumb throttle 0-5V linear. Easy to install on 22mm pipe
€159.00
(tax incl.)
This OZO 35A controller is dual sensored / sensorless field oriented (FOC) sinusoidal mapping, which makes it compatible with all brushless electric motors equipped or not with hall sensors.
Temperature protection to...
€10.00
(tax incl.)
Multifunction switch with two positions.
It can be used as an ON/OFF switch for your lighting or for your OZO controller.
Supplied with 2-pin JST connector.
€15.00
(tax incl.)
Three-position switch to attach to the handlebar of your bike and connect to the dedicated connector of the OZO dual sensorless / sensored controller in order to benefit from three different power modes which are...
Leave a review