Chargement des images...
Base 1
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€10.00
(tax incl.)
Reference:
001897
You may also like
Limited special offer
Limited special offer
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
Limited special offer
€19.00
(tax incl.)
€21.50
The Torque Arm allows to limit the stress on the bike frame, at the level of the wheel fixing beaks, to avoid any deformation.
It is highly recommended for kits over 400W.
€21.00
(tax incl.)
This hexagonal base offers angular freedom that allows it to adapt to all frame geometries.
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on...
Customers who bought this product also bought:
€15.00
(tax incl.)
Three-position switch to attach to the handlebar of your bike and connect to the dedicated connector of the OZO dual sensorless / sensored controller in order to benefit from three different power modes which are...
€4.50
(tax incl.)
The speed sensor magnet is the essential accessory for operating your speed sensor. Simply attached to a spoke of your wheel, it passes in front of the sensor at each rotation to transmit an accurate measurement of...
€1.45
(tax incl.)
We can cut spokes at your convenience.
Conventional rolled 18/8 stainless steel spoke with constant wire diameter from the head to the thread.
13G spokes (2,3mm diameter)
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
Plan "Base 4 M12"
Plan "Base 4 M14"
€90.00
(tax incl.)
The OZO 15A Controller, equipped with Field-Oriented Control (FOC) technology, ensures optimal performance for OZO Brushless motors. Its IP6-rated tropicalization and waterproof connectors provide exceptional...
€199.00
(tax incl.)
The V3 Cycle Analyst is the next step for the CA product line to not only monitor what is going on in an ebike, but also control it. In the V2 CA we included basic throttle over-ride capabilities for speed, current,...
€10.00
(tax incl.)
Multifunction switch with two positions.
It can be used as an ON/OFF switch for your lighting or for your OZO controller.
Supplied with 2-pin JST connector.
Leave a review