€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Under frame controller support
This bracket allows to fix the controller under the frame and to let the cables of the derailleur and the brake pass easily.
€14.99
(tax incl.)
Reference:
001119
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Customers who bought this product also bought:
€12.90
(tax incl.)
This case will allow you to aesthetically fix your 15A 250W controller on the frame of your bike.
The box is installed on the vertical frame tube using two clamps.
Your frame tube should have a maximum diameter of...
€7.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
2D plan of the M5 leg
2D plan of the M6 leg
€299.00
(tax incl.)
This large direct drive motor has a steel stator 35mm wide and a solid axis in 14mm, which allows him to cash a max power of 2000W and to offer a large torque.
It will be perfect for the electrification of a scooter,...
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame.
Plan "Base 3 M12"
€6.50
(tax incl.)
Nylon Battery strap to secure your heavy battery frame and avoid to impact M5 screw on your frame.
Nylon and velcro strap can fit on any frame battery up to 1000Wh
Dimensions : 60cm X 5cm
€19.00
(tax incl.)
The 2 positions selector coudl be used to start the system or switch on the lighting or in order to select between the forward/backward motion.
The red pushing bouton could be used to activate the brake regeneration...
Leave a review