€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Hydraulic brake cutoff for Shimano MT200 and MT401 brakes only.
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating: lP65There are two versions for left/right assembly
€20.00
(tax incl.)
Reference:
009236
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
BRAKE CUT INSTALLATION PLAN
Customers who bought this product also bought:
€20.00
(tax incl.)
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way...
€30.00
(tax incl.)
Thumb throttle with Battery indicator and ON/OOF switch for Ebikes.
You can install it on the right or Left side of your handlebar.
Available in two Voltage: 36V gauge or 48V.
€299.00
(tax incl.)
OZO offers a wide range of 36V Lithium batteries to tailor your electric experience.
Choose your battery capacity based on your desired range. A 1000Wh battery provides twice the range of a 500Wh battery.
Our 36V...
€25.00
(tax incl.)
Main wiring harness (Eb-bus) for 15A and 22A OZO controller working with Bafang protocol.
€15.00
(tax incl.)
Cable extension for electric bicycle hub motor with waterproof connector 9 Pins Julet Z910AT
Available in three lengths:
- 30cm
- 45cm
- 110cm
€12.90
(tax incl.)
Y cable wire to plug 2 sensors on one entry of your Bafang motor BBS01 BBS02 BBSHD maxdrive or any system using Julet connector 3 pins.
With this cable you can plug one or two gear sensors, and plug two brake...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€1.20
(tax incl.)
The anti-rotation washer is essential to lock the flat axle of your hub motor in the frame brackets. By preventing it from turning under the effect of torque, it effectively protects your frame and cables from any...
Leave a review