€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Y cable for brake cut and light
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Customers who bought this product also bought:
€30.00
(tax incl.)
This cable allows you to connect two batteries in parallel on one controller or to connect two controllers to a single battery.
You can also use it with OZO solar charger to charge two batteries at the same time....
€16.90
(tax incl.)
Available in 30cm / 50 cm / 70cm / 1m / 1m20 / 1m50 / 2m
€11.99
(tax incl.)
The SKS Anywhere bottle cage adapter will allow you to create a new bottle cage holder when your gourd battery takes the place of the bottle cage on the frame.
Its two straps can be installed on all kinds of tubes...
€44.00
(tax incl.)
chainring adapter 5 holes for Bafang central motors BBS01 BBS02
Available in 5x130mm / 5x135mm / 5x110mm
With this adapter you can adapt any 5 holes chainring on your Bafang"s motor and even add double transmission....
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
€20.00
(tax incl.)
This universal adapter allows to create new fixing points on the frame of the bike by picking up the fixings of the original bottle holder, in order to facilitate the installation of batteries frames 500Wh, 700Wh,...
€1.45
(tax incl.)
We can cut spokes at your convenience.
Conventional rolled 18/8 stainless steel spoke with constant wire diameter from the head to the thread.
13G spokes (2,3mm diameter)
Leave a review