Integrated PAS sensor for OZO controller 15A and 22A

Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.

Compatible with OZO Touring and Enduro kits.

Very simple installation.

Julet three-way waterproof connector.

Pedal sensor installation instructions

Ebikes pas sensor Kingmeter under bottom bracket

€20.00 (tax incl.)

Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow. Matching with all 15A and 22A OZO controllers. câble length : 150 mm.

12x magnets ring for pedelec sensor

€9.90 (tax incl.)

12x magnets ring for pedelec sensor. Brand : Kingmeter Drive side and opposite side available. For easier installation you can use our support available here

Adaptateur 5 trous côté transmission pour boitier compact

pedelec magnet ring holder adapter

€10.00 (tax incl.)

These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.

adapter pedal board sensor under frame

€10.00 (tax incl.)

This bracket allows the installation of the bottom bracket sensor on the frame under the crankset, when it is not possible to install the bottom bracket sensor on the vertical frame tube. The pedal sensor’s probe is...

Bottom bracket sensor on frame for OZO 15A and 22A controllers

€20.00 (tax incl.)

Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube Supplied with the 12-magnet half discs and the probe. 3-way Julet waterproof connector. Cable length: 120 mm. End to end...

Description

The integrated pedal sensor is a rotation sensor very easy to install for bicycles equipped with a crankset square axis whose gap between the crank and the frame is at least 4mm.

Length of the cable: 60cm