€25.00
(tax incl.)
Magnet ring specially designed for carbon frame road bicycle with compact crankset.
Chargement des images...
Bottom bracket sensor on frame for OZO 15A and 22A controllers
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end length: 180 mm.
If the cable is too short (12cm), we offer you an extension cord.
Installation instructions for the bottom bracket sensor
€20.00
(tax incl.)
Reference:
002189
You may also like
€50.00
(tax incl.)
Gift voucher worth 50 € to 200 €
Valid for 1 year on all products on the site
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€20.00
(tax incl.)
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way...
€10.00
(tax incl.)
This bracket allows the installation of the bottom bracket sensor on the frame under the crankset, when it is not possible to install the bottom bracket sensor on the vertical frame tube.
The pedal sensor’s probe is...
€20.00
(tax incl.)
Pedal sensor in housing for OZO controller 25A and 35A.
For cases with external bearings such as Shimano hollowtech, choose the "transmission side".
Very simple installation.
3-way JST male connector.
Installation...
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side of your bike.
Dimension of sensor :
Customers who bought this product also bought:
€12.90
(tax incl.)
Charging adapter RCA male to Jack Female
Max current : 4A
€29.90
(tax incl.)
10-speed 11-28 cassette in nickel-plated steel compatible with SHIMANO.
Tiering: 11-12-13-14-15-17-19-21-24-28
Weight: 288g.
€9.90
(tax incl.)
for axes of 10, 12 and 14mm
length 4.5 cm
Inner diameter 18.2mm.
€12.90
(tax incl.)
Y cable wire to plug 2 sensors on one entry of your Bafang motor BBS01 BBS02 BBSHD maxdrive or any system using Julet connector 3 pins.
With this cable you can plug one or two gear sensors, and plug two brake...
€19.00
(tax incl.)
Bicycle tail light with mud pad for electric bike.
The advantage of the tail light is that it accepts a voltage range from 6V to 55V.
You can therefore install it on any electric bike.
Consumption of only 2.8W...
Leave a review