Chargement des images...
TORQUE ARM THROUGH AXLE HORNET
You may also like
Limited special offer
Limited special offer
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
Limited special offer
€19.00
(tax incl.)
€21.50
The Torque Arm allows to limit the stress on the bike frame, at the level of the wheel fixing beaks, to avoid any deformation.
It is highly recommended for kits over 400W.
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€21.00
(tax incl.)
This hexagonal base offers angular freedom that allows it to adapt to all frame geometries.
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on...
Customers who bought this product also bought:
€19.00
(tax incl.)
The 1.20 m backpack battery extension is the ideal accessory for installing your battery in a backpack to lighten the frame or equip an all-suspension mountain bike. Its generous length gives you complete freedom of...
€19.00
(tax incl.)
Pedal sensor compatible with the generic 250W controller for the repair of electric bikes.
2 models available: Integrated 12 magnets or V7 6 magnets
The V7 comes with a 6-magnet magnetic washer.
Cable length of 60 cm...
€10.00
(tax incl.)
Eb-bus extender for main harness on your OZO conversion kit.
exists in 3x lengths : 30cm, 80cm, 1m
€6.50
(tax incl.)
Nylon Battery strap to secure your heavy battery frame and avoid to impact M5 screw on your frame.
Nylon and velcro strap can fit on any frame battery up to 1000Wh
Dimensions : 60cm X 5cm
€20.00
(tax incl.)
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end...
€8.00
(tax incl.)
This extension cable has a 3-way JST connector for pedal sensor or accelerator. With switch 3-Position. Available in 3 lengths :
30 cm
50 cm
100 cm
Leave a review