€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Potentiometer support for CA
Support for potentiometer to screw on the back of the V2 or V3 analyst cycle
€15.00
(tax incl.)
Reference:
000099
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Customers who bought this product also bought:
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
€18.00
(tax incl.)
Specific three-position switch for the V3 analyst cycle.
This switch integrates resistors on each mode and will allow you to define three different assistance algorithms by activating the "auxiliary" setup of your V3...
€8.90
(tax incl.)
Ce support d'accessoire double peut etre installer facilement sur tous les guidons de diamètre 25 mm à 31.8 mm. Il vous permettra notamment d'installer votre display ainsi que la gachette d'accélérateur au pouce....
€15.00
(tax incl.)
This brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles
It is quick to install on the brake handle or caliper....
€15.00
(tax incl.)
Three-position switch to attach to the handlebar of your bike and connect to the dedicated connector of the OZO dual sensorless / sensored controller in order to benefit from three different power modes which are...
€20.00
(tax incl.)
This cable allows to update your cycle analyst with the last software version and also to read and set all datas on your computer.
€2.00
(tax incl.)
hub motor nut
M12 for all motors from 250W to 750W
M14 for 1000W motors
€119.00
(tax incl.)
The OZO controller 12V 24V 36V 48V integrates high quality electronic components from the automotive world.
Dual sensored / sensorless adaptive field-oriented sinusoidal mapping (FOC) will allow you to power all...
Leave a review