€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Temperature sensor for CA V3
The temperature sensor for CA V3 is the essential safety accessory to protect your engine against overheating. Connected directly to your Cycle Analyst V3 on-board computer, it measures the internal temperature of your engine in real time. This allows the system to automatically regulate the power of the assistance in case of heavy load or long ascent, thus sustainably preserving your electrical components.
€2.50
(tax incl.)
Reference:
000100
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Customers who bought this product also bought:
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side.
€31.90
(tax incl.)
The quality of its compound ensures low rolling resistance and excellent grip for a very good level of safety, even in bends negotiated at high speed.
The entire Energizer range has ECE-R75 certification allowing it...
€20.00
(tax incl.)
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end...
€8.90
(tax incl.)
Ce support d'accessoire double peut etre installer facilement sur tous les guidons de diamètre 25 mm à 31.8 mm. Il vous permettra notamment d'installer votre display ainsi que la gachette d'accélérateur au pouce....
€10.00
(tax incl.)
This red pushing button is expected to be installed on a handlebar or a 22mm tube.
On a bike or a motorcycle, it can be used to stop the motor when it's plugged in on the controller break brake or disactivate the...
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
Leave a review