€12.90
(tax incl.)
Anderson PP30 to XT60 female cable adapter
Chargement des images...
Anderson extension to M6 eyebolt
You may also like
€24.90
(tax incl.)
This 50cm cable get Anderson PP30 and MC4 Solar solar connectors. ideal to connect your solar panels to your OZO 300W or 600W or Genasun solar charger.
€29.99
(tax incl.)
Charging adapter: Anderson to clamps : for Lithium Iron LFP battery with terminals
dimension: 40cm
€12.90
(tax incl.)
Solar recharge wire Anderson to Jack male or female for cycle analyst
€12.90
(tax incl.)
Charging adapter XLR female to RCA male
Max current : 4A
€12.90
(tax incl.)
Solar recharge wire Anderson to RCA male or female for cycle analyst
€12.90
(tax incl.)
Charging adapter XLR male to Jack female DC 2.1mm
Max current : 4A
Customers who bought this product also bought:
€199.00
(tax incl.)
The OZO controller 24V 36V 48V 60A integrates high quality electronic components from the automotive world. For electric motors above 1500W and up to 5000W
Dual sensored / sensorless adaptive field-oriented...
€39.90
(tax incl.)
Charger for Lithium battery of VAE, electric bike and electric scooter equipped with a Lithium 48V LiMn battery.
We offer 3 charging current values, directly influencing the speed of the battery recharge.
The standard...
€25.00
(tax incl.)
This "half-handle" type accelerator incorporates a push button that can allow you to turn the engine off when connected to the controller's "brake off" input or to disable the cruise control or activate the horn built...
€2.50
(tax incl.)
The temperature sensor for CA V3 is the essential safety accessory to protect your engine against overheating. Connected directly to your Cycle Analyst V3 on-board computer, it measures the internal temperature of...
€2.50
(tax incl.)
Standard screw set (matching screws and nuts), designed to ensure a simple and solid mechanical fastening of your components.
€10.00
(tax incl.)
These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame.
Torque arm 1 2D plane
€19.00
(tax incl.)
Programming cable to program your kelly controller on your computer.
You will also need RS232 to USB adapter câble adaptateur RS232-USB.
Leave a review