€50.00
(tax incl.)
Gift voucher worth 50 € to 200 €
Valid for 1 year on all products on the site
Chargement des images...
Half handle with battery gauge 36V or 48V
Half handle lock on type with battery gauge 36V or 48V.
The LEDs give you an idea of the remaining energy in the battery: 20%, 50%, 100%.
It incorporates a two-position switch
€35.00
(tax incl.)
Reference:
002214
You may also like
€25.00
(tax incl.)
Half throttle for ebikes.
Delivered with JST 3 pins male connector.
Easy to install with "lock-on" collar
€25.00
(tax incl.)
This half handle accelerator is compatible with all our kits.
The two-position switch can be used to turn off the engine if it is wired to the "brake off" input of the controller or to power your lighting.
€25.00
(tax incl.)
This "half-handle" type accelerator incorporates a push button that can allow you to turn the engine off when connected to the controller's "brake off" input or to disable the cruise control or activate the horn built...
The new half handle has a much smaller outer diameter than the old one, which allows a perfect integration on the handlebar without affecting the gearshift. The LEDs give you an idea of the energy remaining in the battery: 20%, 50% %, 100%. It incorporates a two-position switch that will allow you to shut down the engine when wired to the controller's "brake cutoff" input or to power your lighting.
Drawing
Customers who bought this product also bought:
€25.00
(tax incl.)
speed control device for electric bicycle.
On the same principle as your car’s cruise control: you select a cruising speed, you release the accelerator and the electronics regulate the engine power to maintain a...
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€15.00
(tax incl.)
Electronic card on which the magnet of the pedal sensor passes.
€7.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
2D plan of the M5 leg
2D plan of the M6 leg
€35.00
(tax incl.)
Battery bag frame that allows to install all our PVC batteries : 36V9Ah ; 36V 12Ah; 36V 14Ah ; 48V 12Ah; 48V 14Ah.
You can select to get one neiman with Key.
Dimensions = 29 x 8,5 x 9,2cm
€20.00
(tax incl.)
Universal thumb throttle 0-5V linear. Easy to install on 22mm pipe
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
Plan "Base 4 M12"
Plan "Base 4 M14"
Leave a review