Home
>
Industry
>
Cables
>
Motor industrial extension

Chargement des images...

Motor industrial extension

Industrial motor extension made up of :

3 phase pins
5 pins Hall sensors
1 temperature pi

Y splitter cable 3 pins JST for throttle

€24.90 (tax incl.)

Y splitter cable to connect one throttle on both controllers. Allows to drive simultanouesly two motors with one throttle. 3 pins JST connectors compatible with OZO controllers 25A, 35A, 40A, 60A and Kelly controllers...

Description

Cable size: 1m20

Leave a review

Frequently questions

Send us your question

Be the first to ask a question about this product!

Consult, revoke or modify data

Customers who bought this product also bought:

Main wiring harness for 15A and 22A OZO controller

€25.00 (tax incl.)

Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.

Schwalble Marathon Plus MTB tire 26 to 29''

€49.90 (tax incl.)

ECE-R75 approved for the fastest electric bikes.Its central tread allows it to tackle the most difficult paths and its side knobs give it fantastic traction in Off-Road.Also supplied with SmartGuard protection for...

Contact brake MT5e

€144.90 (tax incl.)

Can fit on OZO kits with 15A and 22A controller. Original length of the hose 2m20Hydraulic system.

Cable for brushless motor 3x2.00mm² + 6x0.20mm²

€8.00 (tax incl.)

Limited special offer

Torque Arm Frame clamp 1 in STAINLESS STEEL

€25.00 (tax incl.) €28.50

The base 3 is in stainless steel of 6.20mm thickness. To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame. Plan "Base 3 M12"

45cm battery extension

€10.00 (tax incl.)

Extension cable with a length of 45 cm, equipped with high quality power connectors to ensure a reliable and secure electrical connection between your battery and your controller. Its section is perfectly sized to...

Y cable for brake cut and light

€12.90 (tax incl.)

TORQUE ARM Base 3

€12.00 (tax incl.)

In 6.20 mm thick stainless steel To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame. Plan "Base 3 M12"