Chargement des images...
Motor cable adapter Anderson JST to Julet 11-way female
You may also like
€6.50
(tax incl.)
Julet Z309AG waterproof connector 2m length cable
€5.90
(tax incl.)
2m length cable with Julet waterproof connector Z209AG red
€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
€39.00
(tax incl.)
High Power cable 50mm2 1/0 gauge for electric motors up to 20kW or batteries.
Red cable allows you to power your motorcycle, kart, quad, audio, car, solar, marine installation up to 375A with the 1/0 gauge cable...
€39.90
(tax incl.)
Power cable 95mm2 760A black extra flexible multi-stranded for battery or DC motor power supply. Extra flexible cable with high-temperature silicone insulation 200°C
Sale by the meter
€24.90
(tax incl.)
Power cable 50mm2 400A 600V DC black extra flexible stranded for battery or DC motor power supply. Extra flexible cable with high-temperature silicone insulation 200°C
Sale by the meter
Customers who bought this product also bought:
€25.00
(tax incl.)
Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.
€2.50
(tax incl.)
The temperature sensor for CA V3 is the essential safety accessory to protect your engine against overheating. Connected directly to your Cycle Analyst V3 on-board computer, it measures the internal temperature of...
€14.99
(tax incl.)
This bracket allows to fix the controller under the frame and to let the cables of the derailleur and the brake pass easily.
€7.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
2D plan of the M5 leg
2D plan of the M6 leg
€15.00
(tax incl.)
Three-position switch to attach to the handlebar of your bike and connect to the dedicated connector of the OZO dual sensorless / sensored controller in order to benefit from three different power modes which are...
€9.90
(tax incl.)
for axes of 10, 12 and 14mm
length 4.5 cm
Inner diameter 18.2mm.
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
Leave a review