Filters
Composant ki
€30.00
(tax incl.)
Universal shunt 1mOhm for V2 and V3 analyst cycles. You can use the analyst cycle on any controller, solar panel, or charger. Supports a direct current of 50A and a max current of 100A
€20.00
(tax incl.)
Did you lose the key to your electric bike battery? Replace your lock with this original model.
Barrel identical for SilverFish SSE-014 models or other aluminum housings as on the brands: Hilltecks, Gitane, Moma...
€40.00
(tax incl.)
12V 15A controller to power a brushless motor operating in 12V.
Sensorless only.
Ideal for powering scooter motors in 5" or 6"
The controller has the safety function "pedal first", that is to say that it is...
€15.00
(tax incl.)
JST magnetic contact to activate the brake cut-off on a bike equipped with hydraulic brakes.
4-way JST connector for compatibility with OZO controllers.
You keep your original hydraulic brakes.
Cable length = 700mm
€169.00
(tax incl.)
The OZO 35A controller is specially designed for our speedster RH212 rear hub direct drive motor with waterproof connector Julet 1121AG.
Can also fit front hub motor FH212
Only compatible with OZO vertical display...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
€15.00
(tax incl.)
Cable extension for electric bicycle hub motor with waterproof connector 9 Pins Julet Z910AT
Available in three lengths:
- 30cm
- 45cm
- 110cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€39.00
(tax incl.)
TK15H is a high precision current type battery capacity tester (also known as coulometer), which can test battery voltage, current and capacity to help users know the battery condition in time. TK15H have memory...
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side of your bike.
€45.00
(tax incl.)
Mini scooter or kick scooter controller 36V 250W. Pedal first function, lcd display, active regenerative braking with throttle
€40.00
(tax incl.)
Electric Foot Throttle Electric Scooter Foot Gas Pedals
Voltage : 0-5V
Lenght : 1.2m
Connector : JST 3 pins
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
OZO offers a wide range of components for electric bicycles for the optimization or repair of electric bicycles with wheel motor or pedal motor.
