€9.90
(tax incl.)
Accelerator stand straight or elbow shaped for wheelbarrow, cart, agricultural and industrial machinery
Filters
Composant ki
€20.00
(tax incl.)
Standard cable with special lugs for screw terminal block of KELLY controllers.
Standard length: 35cm / Optional extension possible: 50cm, 1m, 1.5m
Cable section: 13AWG / 2,5mm2
+ after wired contact to...
€10.00
(tax incl.)
This green pushing button switch is expected to be installed on a handlebar or a 22mm tube.
On a bike or a motorcycle, it can be used to stop the motor when it's plugged in on the controller break brake or...
€5.00
(tax incl.)
2-way extension cable for temperature and ON/OFF switch's controller of 25A & 35A.
Available in 4 lengths
20cm
50cm
100cm
140cm
€160.00
(tax incl.)
Karting bracket in 316L stainless steel, available in 6mm and 8mm thickness. Designed for mounting in place of the combustion engine, directly on the flanges.
Compatibility :
-6mm thickness: 3.5kW and 6kW motors...
€19.00
(tax incl.)
The pedal sensor is a rotation sensor. You are required to pedal for assistance and you cannot precisely dose the desired level of assistance since this level is determined by a law of assistance specific to the...
€8.00
(tax incl.)
Capacity Leds gauge for Lithium batteries. Select the appropriate voltage : 24V, 36V and 48V.
5x leds ON when battery is full of charge.
€1.45
(tax incl.)
Black stainless steel spoke 13G
Made in France
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
€10.00
(tax incl.)
This brake extension cable has a JST connector available in :
- 30cm
- 50cm
€10.00
(tax incl.)
Multifunction interruptor with 2 positions
It can be used as a switch for your lighting or your OZO controller
Delivered with 2 JST ways connector
€249.00
(tax incl.)
This central rotor Brushless PMSM electric motor is designed to deliver a power of 1000W at 72V, generating a torque of 12 Nm. This is equivalent to a thermal power of 2CV.
It will be perfect for retrofitting a...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€7.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
2D plan of the M5 leg
2D plan of the M6 leg
€1.45
(tax incl.)
We can cut spokes at your convenience.
Conventional rolled 18/8 stainless steel spoke with constant wire diameter from the head to the thread.
13G spokes (2,3mm diameter)
€20.00
(tax incl.)
This ebike accelerator is thumb operated.
An exact copy of the accelerators found on quads or water scooters.
Note that you can only install this accelerator if you have previously removed a derailleur lever....
€10.00
(tax incl.)
Multifunction interruptor with 2 positions
It can be used as a switch for your lighting or your OZO controller
Delivered with 2 JST ways connector
OZO offers a wide range of components for electric bicycles for the optimization or repair of electric bicycles with wheel motor or pedal motor.
