€12.50
(tax incl.)
With 5-way JST box with 4 cables.Available in 50cm and 1m.
Chargement des images...
Speed sensor for cycle analyst
The speed sensor for Cycle Analyst is the ideal accessory to accurately measure your actual speed and distance traveled on your electric bike. Connected directly to your on-board computer, this sensor works with a magnet attached to the wheel to provide reliable data in real time, even when the motor is freewheeling. It is the essential tool for accurate performance monitoring and optimal management of your battery life.
€16.00
(tax incl.)
Reference:
001816
You may also like
€50.00
(tax incl.)
Current measuring device allowing to connect and monitor simultaneously two controllers or energy sources on a single Cycle Analyst screen. It is the ideal accessory to accurately monitor the consumption of a...
€10.00
(tax incl.)
6-way extension cable cycle analyst
30cm
50cm
100cm
€45.00
(tax incl.)
16A Hall Effect Current Sensor for Solar CA V3 Firmware. This shunt is great for solar application such as long travel, suntrip... you will be able to check your production and consumption on the same CA V3 screen.
€45.00
(tax incl.)
Slim digital up and down pushing buttons for limit setttings by pushing buttons as pedal assist limit.
Requires a Cycle Analyst with version 3.1 or later firmware.
Connects to white 3-pins Aux plug on CA3 device.
€24.90
(tax incl.)
This USB charger converter allows to charge any smartphone or camera or GPS directly with any 12V 24V 36V 48V 60V battery.
Output is 5V 2A
Input voltage has to be between 10V and 60V
44x21x11mm
Easy to use
€20.00
(tax incl.)
This potentiometer support for cycle analyst V3, allows an installation of the potentiometer closer to the handle and will allow you to clamp the torque, speed or power of your engine without leaving the hands of the...
€9.90
(tax incl.)
This spacer allows the speed sensor to be offset if it is too far from the magnet.
Essential on fat bikes.
Customers who bought this product also bought:
€10.00
(tax incl.)
This bracket allows the installation of the bottom bracket sensor on the frame under the crankset, when it is not possible to install the bottom bracket sensor on the vertical frame tube.
The pedal sensor’s probe is...
€10.00
(tax incl.)
Bafang speed sensor extension cable 30cm for BBS01 BBS02 BBSHD
€179.00
(tax incl.)
Controller 48V to 72V - 40A dual sensored sensorless for brushless motor.
Compatible with cycle analsyt V2 andV3, throttle, pas sensor, cruise control, backward and forward selection, ebrake cut off, regen...
€20.00
(tax incl.)
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end...
€25.00
(tax incl.)
Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.
€599.00
(tax incl.)
OZO offers an extensive range of 48V Lithium batteries to tailor your electric experience.
Choose your battery capacity based on your range requirements. A 1000Wh battery will provide you with 33% more range compared...
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side.
Leave a review