€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Main wiring harness for 15A and 22A OZO controller
Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.
€25.00
(tax incl.)
Reference:
000801
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.
2 Red connectors
1 Green connector
1 yellow connector
Compatible with all VAEs which have a 9-way Julet connector. Example: Nakamura, Kunteng, Gosport, Norauto, Peugeot ...
Length 50 cm
Customers who bought this product also bought:
€19.00
(tax incl.)
The 1.20 m backpack battery extension is the ideal accessory for installing your battery in a backpack to lighten the frame or equip an all-suspension mountain bike. Its generous length gives you complete freedom of...
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€5.00
(tax incl.)
2-way extension cable for temperature and ON/OFF switch's controller of 25A & 35A.
Available in 4 lengths
20cm
50cm
100cm
140cm
€11.99
(tax incl.)
The SKS Anywhere bottle cage adapter will allow you to create a new bottle cage holder when your gourd battery takes the place of the bottle cage on the frame.
Its two straps can be installed on all kinds of tubes...
€12.00
(tax incl.)
Extension cable Julet for bafang display 5 pins or OZO display
30cm length
€9.00
(tax incl.)
Extension for brake handle with cut-off point with sealed Julet 2-way connector for 15A and 22A controller
Julet red 2-way connector compatible with many commercial electric bikes: Cycoo V-5500, TopLife V-5500,...
Leave a review