Chargement des images...
Screws for torque arm collar
The torque arm clamp screws include all the necessary screws, nuts and washers to securely connect your reaction arm (torque arm) to the clamp fixed on the frame or fork of your bike.
Subject to high torsional stresses and continuous vibrations from the drive, these screws are made of high-strength steel or stainless steel. It generally incorporates lock nuts (Nylstop) to eliminate any risk of accidental release. This is the essential mounting kit to ensure the perfect support of your hub motor and durably protect the mounting brackets of your frame.
€3.00
(tax incl.)
Reference:
001868
You may also like
Limited special offer
Limited special offer
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
Limited special offer
€19.00
(tax incl.)
€21.50
The Torque Arm allows to limit the stress on the bike frame, at the level of the wheel fixing beaks, to avoid any deformation.
It is highly recommended for kits over 400W.
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
Customers who bought this product also bought:
€8.90
(tax incl.)
The crank lever is the essential tool for properly removing the cranks from your bike during the installation of your electrical kit. Whether you need to mount a crankset motor or position a pedaling sensor (PAS),...
€9.90
(tax incl.)
for axes of 10, 12 and 14mm
length 4.5 cm
Inner diameter 18.2mm.
€15.00
(tax incl.)
JST magnetic contact to activate the brake cut-off on a bike equipped with hydraulic brakes.
4-way JST connector for compatibility with OZO controllers.
You keep your original hydraulic brakes.
Cable length = 700mm
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
Plan "Base 4 M12"
Plan "Base 4 M14"
€9.90
(tax incl.)
This tool will allow you to unscrew the cups of your square-axis bottom bracket.
€7.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
2D plan of the M5 leg
2D plan of the M6 leg
€5.00
(tax incl.)
Advertised price in meter
Increase the amount to increase the length.
€79.00
(tax incl.)
OZO offers 3x different display models. The display is the screen on the ebikes handlebar. It shows all electrical and run datas such as battery state of charge, speed, distance and allows to select the assist power...
Leave a review