Kit scooter motor electric wheel 750W with battery frame 36V

The "Donkey"   motor is a reduction motor with reinforced planetary gear and internal freewheel. 

The "Donkey" motor  is supplied with lock washers which will allow you to center the wheel in your frame. It can be installed on all traditional frames equipped with a front axle with 100mm center distance.

You can screw your standard 6-hole brake disc onto the motor. 

With your kit you receive a  complete drive wheel.  All our wheels are carefully radiated in our workshop by enthusiasts: spoke tension, centering, runout and runout, everything is checked before shipment.

The 36 spokes are made of stainless steel, 2.3mm in diameter, made in France.

 These French-made rims will allow you to use your kit in all conditions.

The  25A controller  is very easy to install. Each connector has a key, you have no risk of making a mistake.

This controller is only compatible with all OZO batteries

You will find all the batteries dimensions "frame" in the tab " Documentation " and the detailed description on the page " framework Battery 36V "

This charger is  one of the lightest on the market , with these 200g. Ideal to carry it everywhere with you on your expeditions and your travels.

Totally silent , you can recharge your battery without being disturbed.

This charger is designed to charge Lithium batteries with a nominal voltage of 36V.

The accelerator  offers the possibility of controlling the engine without pedaling. 

In the form of a thumb trigger, the throttle can be installed on the right or left of the handlebars.

Note, however, that the accelerator is not approved for driving on a road open to traffic. 

The torque arm  is a laser-cut stainless steel part that prevents loosening of the drive wheel fixing nuts so as not to damage the frame of your scooter.

The torque arm is essential with the 750W Scooter kit.

To choose the right model for your scooter, OZO will select the most suitable model for you.

The wheel kit  is compatible with all scooters equipped with a 9x100mm or 10x100mm front wheel axle.

To be sure that the installation is possible on your bike, you must check that you have a traditional frame open with 100mm center distance.

With a ruler, measure the inside width of your frame (value A). You must have at least 100mm (10cm).

Then measure the frame notches (value B). You must have 9 or 10mm.