€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Rallonge câble pieuvre EB-BUS
Eb-bus extender for main harness on your OZO conversion kit.
exists in 3x lengths : 30cm, 80cm, 1m
€10.00
(tax incl.)
Reference:
002706
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Customers who bought this product also bought:
€59.00
(tax incl.)
These modules allow for the parallel connection of batteries to increase their autonomy.
Compatible only with generic batteries of the same voltage, although the battery capacity may vary.
The small module is...
€20.00
(tax incl.)
This ebike accelerator is thumb operated.
An exact copy of the accelerators found on quads or water scooters.
Note that you can only install this accelerator if you have previously removed a derailleur lever....
€5.00
(tax incl.)
The Stretch Neoprene Base Protector for bicycles provides protection against scratches, impacts, and outdoor elements.
Made of neoprene, it fits snugly around the bike base, and its velcro system ensures a secure,...
€9.90
(tax incl.)
This spacer allows you to adapt a speed sensor to a wider frame (fatbike type).
It is sold with 4 plastic clamps.
Leave a review