€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
EB-BUS 10-pin octopus cable extension with lighting output for OZO wheel motor kit
Eb-bus extender for main harness on your OZO conversion kit.
exists in 3x lengths : 30cm, 80cm, 1m
€10.00
(tax incl.)
Reference:
002706
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Customers who bought this product also bought:
€14.00
(tax incl.)
The Shimano Tourney 7-speed shifter is the ideal control to replace or upgrade your drivetrain when installing your electrical kit. Reliable, robust and economical, it ensures smooth and precise gear shifting,...
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€25.00
(tax incl.)
Bafang Eb-bus wiring harness for central motors BBS01 BBS02 BBSHD
€7.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
2D plan of the M5 leg
2D plan of the M6 leg
€299.00
(tax incl.)
Bobber is rear hub electric motor 36V 250W
Light and efficient it's the right choice for city bike, folding bike or road bicycle.
Bobber is available in 200RPM to reach 25Km/h. It's a geared motor with 1:4,43 ratio....
€20.00
(tax incl.)
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end...
Leave a review