€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Main wiring harness for 15A and 22A OZO controller BFG
Main wiring harness (Eb-bus) for 15A and 22A OZO controller working with Bafang protocol.
€25.00
(tax incl.)
Reference:
000329
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Main wiring harness Eb-bus for 15A and 22A OZO controller
1 red JULET female 2 pins Z210AM for ebrakes
1 red JULET mâle 2 pins Z210AG for light
1 green JULET mâle 5 pins Z205AG for display
1 yellow JULET mâle 3 pins Z310AG for throttle
Customers who bought this product also bought:
€8.90
(tax incl.)
This front light bracket has been specially designed to make it easy to attach your bike's front light. Thanks to this practical holder, you can easily attach it to your bike's handlebars.
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
€4.50
(tax incl.)
gasket for Bafang bottom bracket shaft on central Bafang motors BBS01 BBS02. M215 , M315 G340 250W 500W et 750W
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
Plan "Base 4 M12"
Plan "Base 4 M14"
€20.00
(tax incl.)
Motor cable extender 45cm and 1m
Extension for motor cable with 3x 2.00mm2 cables for the phases and 5x 0.22mm2 cables for the HALL sensors.
The extensions are supplied with Anderson PP30 connectors for the phases...
Leave a review