€25.00
(tax incl.)
Magnet ring specially designed for carbon frame road bicycle with compact crankset.
Chargement des images...
Pedal sensor on frame for OZO 25A controller JST
You may also like
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€20.00
(tax incl.)
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way...
€10.00
(tax incl.)
This bracket allows the installation of the bottom bracket sensor on the frame under the crankset, when it is not possible to install the bottom bracket sensor on the vertical frame tube.
The pedal sensor’s probe is...
€20.00
(tax incl.)
Pedal sensor in housing for OZO controller 25A and 35A.
For cases with external bearings such as Shimano hollowtech, choose the "transmission side".
Very simple installation.
3-way JST male connector.
Installation...
€20.00
(tax incl.)
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end...
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side of your bike.
€19.00
(tax incl.)
Pedal sensor compatible with the generic 250W controller for the repair of electric bikes.
2 models available: Integrated 12 magnets or V7 6 magnets
The V7 comes with a 6-magnet magnetic washer.
Cable length of 60...
Dimension of sensor :
Customers who bought this product also bought:
€5.00
(tax incl.)
Original protective cover for Bafang pedal motor.
Only compatible with Bafang BBS01/BBS02 pedals.
Available in 44 teeth or 46/48 teeth
Not compatible with BBSHD.
€25.00
(tax incl.)
speed control device for electric bicycle.
On the same principle as your car’s cruise control: you select a cruising speed, you release the accelerator and the electronics regulate the engine power to maintain a...
€14.99
(tax incl.)
This bracket allows to fix the controller under the frame and to let the cables of the derailleur and the brake pass easily.
€15.00
(tax incl.)
Cable extension for electric bicycle hub motor with waterproof connector 9 Pins Julet Z910AT
Available in three lengths:
- 30cm
- 45cm
- 110cm
€35.00
(tax incl.)
Half handle lock on type with battery gauge 36V or 48V.
The LEDs give you an idea of the remaining energy in the battery: 20%, 50%, 100%.
It incorporates a two-position switch
€15.00
(tax incl.)
The JST contact brake lever includes an essential motor cut-off system to ensure your safety on the electric bike. As soon as you apply the brake, it sends an instant signal to the controller to immediately stop the...
€20.00
(tax incl.)
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end...
Leave a review