Chargement des images...
Pack Torque arm to screw M5 / M6
The Torque Arm allows to limit the stress on the bike frame, at the level of the wheel fixing beaks, to avoid any deformation.
It is highly recommended for kits over 400W.
Limited special offer
€19.00
(tax incl.)
€21.50
Reference:
001027
You may also like
Limited special offer
Limited special offer
Limited special offer
€25.00
(tax incl.)
€28.50
The base 3 is in stainless steel of 6.20mm thickness.
To check the installation of the torque arm on your bike, you can print the plan below, cut the part and position it on the frame.
Plan "Base 3 M12"
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€21.00
(tax incl.)
This hexagonal base offers angular freedom that allows it to adapt to all frame geometries.
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on...
Customers who bought this product also bought:
€19.00
(tax incl.)
The 1.20 m backpack battery extension is the ideal accessory for installing your battery in a backpack to lighten the frame or equip an all-suspension mountain bike. Its generous length gives you complete freedom of...
€199.00
(tax incl.)
The V3 Cycle Analyst is the next step for the CA product line to not only monitor what is going on in an ebike, but also control it. In the V2 CA we included basic throttle over-ride capabilities for speed, current,...
€29.90
(tax incl.)
SHIMANO compatible 10-speed 11-36 cassette.
Tiering: 11-12-13-15-18-21-24-28-32-36
Weight: 450g.
€25.00
(tax incl.)
The protective cover for frame battery provides protection against bad weather, dirt ... Made of neoprene, it also offers a thermal insulation beneficial to the autonomy and the life of the battery of your VAE....
€9.90
(tax incl.)
This tool will allow you to unscrew the cups of your square-axis bottom bracket.
€15.00
(tax incl.)
Three-position switch to attach to the handlebar of your bike and connect to the dedicated connector of the OZO dual sensorless / sensored controller in order to benefit from three different power modes which are...
€25.00
(tax incl.)
Main wiring harness (Eb-bus) for 15A and 22A OZO controller working with Bafang protocol.
€79.00
(tax incl.)
OZO offers you to choose from three models of displays with Bafang protocol UART 5.2 and 5.8 with cylindric green 5 pins female connector.
Compatible with all bbs series central motor from Bafang and some OZO hub...
Leave a review