€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Hydraulic brake cutoff for Shimano MT200 and MT401 brakes only.
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating: lP65There are two versions for left/right assembly
€20.00
(tax incl.)
Reference:
009236
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
BRAKE CUT INSTALLATION PLAN
Customers who bought this product also bought:
€16.90
(tax incl.)
Available in 30cm / 50 cm / 70cm / 1m / 1m20 / 1m50 / 2m
€9.00
(tax incl.)
Extension for brake handle with cut-off point with sealed Julet 2-way connector for 15A and 22A controller
Julet red 2-way connector compatible with many commercial electric bikes: Cycoo V-5500, TopLife V-5500,...
€90.00
(tax incl.)
The OZO 15A Controller, equipped with Field-Oriented Control (FOC) technology, ensures optimal performance for OZO Brushless motors. Its IP6-rated tropicalization and waterproof connectors provide exceptional...
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€6.50
(tax incl.)
Nylon Battery strap to secure your heavy battery frame and avoid to impact M5 screw on your frame.
Nylon and velcro strap can fit on any frame battery up to 1000Wh
Dimensions : 60cm X 5cm
€25.00
(tax incl.)
Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame.
Torque arm 1 2D plane
Leave a review