€25.00
(tax incl.)
Magnet ring specially designed for carbon frame road bicycle with compact crankset.
Chargement des images...
Bottom bracket sensor on frame for OZO 15A and 22A controllers
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end length: 180 mm.
If the cable is too short (12cm), we offer you an extension cord.
Installation instructions for the bottom bracket sensor
€20.00
(tax incl.)
Reference:
002189
You may also like
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€20.00
(tax incl.)
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way...
€10.00
(tax incl.)
This bracket allows the installation of the bottom bracket sensor on the frame under the crankset, when it is not possible to install the bottom bracket sensor on the vertical frame tube.
The pedal sensor’s probe is...
€20.00
(tax incl.)
Pedal sensor in housing for OZO controller 25A and 35A.
For cases with external bearings such as Shimano hollowtech, choose the "transmission side".
Very simple installation.
3-way JST male connector.
Installation...
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side of your bike.
€19.00
(tax incl.)
Pedal sensor compatible with the generic 250W controller for the repair of electric bikes.
2 models available: Integrated 12 magnets or V7 6 magnets
The V7 comes with a 6-magnet magnetic washer.
Cable length of 60 cm...
Dimension of sensor :
Customers who bought this product also bought:
€16.00
(tax incl.)
The speed sensor for Cycle Analyst is the ideal accessory to accurately measure your actual speed and distance traveled on your electric bike. Connected directly to your on-board computer, this sensor works with a...
€10.00
(tax incl.)
These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.
€25.00
(tax incl.)
Thanks to additional information which will be requested from you later, OZO will determine the most suitable pedal sensor for your bike. If you know the model you need, do not hesitate to tell us "in comment" when...
€29.00
(tax incl.)
Industrial motor extension made up of :
3 phase pins
5 pins Hall sensors
1 temperature pi
€0.50
(tax incl.)
Motor shaft spacers are available for any kind of ebikes motor hub and allows to center the wheel inside the frame.
€139.00
(tax incl.)
Brushless motor wheel to convert into electric any industrial trolley :
Leisure and service (golf cart, refrigerated cart, stroller, prototyping)
Industrial (rolling base, industrial serving trolleys pusher puller)...
Leave a review