€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Rallonge moteur 9 PINS 110cm
Cable extension for electric bicycle hub motor with waterproof connector 9 Pins Julet Z910AT
Available in three lengths:
- 30cm
- 45cm
- 110cm
€15.00
(tax incl.)
Reference:
009152
You may also like
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€149.00
(tax incl.)
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Customers who bought this product also bought:
€4.50
(tax incl.)
gasket for Bafang bottom bracket shaft on central Bafang motors BBS01 BBS02. M215 , M315 G340 250W 500W et 750W
€20.00
(tax incl.)
This 33cm brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles
It is quick to install on the brake handle or caliper....
€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
€12.90
(tax incl.)
Charging adapter XLR female to Jack male
Max current : 4A
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
Leave a review