0

Composant ki

Capteur pédalier V5 Capteur pédalier V5

Pedal sensor for generic OZO controller

€19.00 (tax incl.)
Pedal sensor compatible with the generic 250W controller for the repair of electric bikes. 2 models available: Integrated 12 magnets or V7 6 magnets The V7 comes with a 6-magnet magnetic washer. Cable length of 60 cm...
Accélérateur gachette au pouce Accélérateur gachette au pouce

Half handle accelerator with push button

€25.00 (tax incl.)
This "half-handle" type accelerator incorporates a push button that can allow you to turn the engine off when connected to the controller's "brake off" input or to disable the cruise control or activate the horn built...
KELLY battery cable with 50A Anderson connector

KELLY battery cable with 50A Anderson connector

€33.60 (tax incl.)
Standard cable with special lugs for screw terminal block of KELLY controllers. Standard length: 35cm / Optional extension possible: 50cm, 1m Cable section: 10AWG / 5mm2 + after wired contact to switch on the...
Ralonge moteur avec phase et capteur HALL Ralonge moteur avec phase et capteur HALL

Motor cable extender 45cm and 1m anderson PP30 / JST

€20.00 (tax incl.)
Motor cable extender 45cm and 1m Extension for motor cable with 3x 2.00mm2 cables for the phases and 5x 0.22mm2 cables for the HALL sensors. The extensions are supplied with Anderson PP30 connectors for the phases...
Interrupteur 2 positions rond vert ON-OFF pour vélo Interrupteur 2 positions rond vert ON-OFF pour vélo

2-position black switch

€12.00 (tax incl.)
Multifunction two-position switch. It can be used as a forward/reverse switch, ON/OFF for your lighting, or for your OZO controller. Supplied with a 2-way JST connector.
Capteur pédalier V5 Capteur pédalier V5

V5 pedal sensor

€19.00 (tax incl.)
The pedal sensor is a rotation sensor. You are required to pedal for assistance and you cannot precisely dose the desired level of assistance since this level is determined by a law of assistance specific to the...
Demi-poignée d'accélérateur avec bouton On Off Demi-poignée d'accélérateur avec bouton On Off

Half handle accelerator with 2 position button

€25.00 (tax incl.)
This half handle accelerator is compatible with all our kits. The two-position switch can be used to turn off the engine if it is wired to the "brake off" input of the controller or to power your lighting.
Base 1

Base 1

€10.00 (tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame. "Base 1 M12" plan "Base 1 M14" plan
Controller Kelly motor cable Controller Kelly motor cable

Controller Kelly motor cable

€36.00 (tax incl.)
Standard motor cable with special lugs for screw terminal block of KELLY controllers. Standard length: 35cm / Optional extension possible: 45cm, 1,1m. Cable section: 10AWG / 5mm2 + after wired contact to switch on the...
BBSHD 42T chainring BBSHD 42T chainring
Limited special offer

Bafang 1000W BBSHD 48V mid drive motor kit without battery

€939.00 (tax incl.) €1,021.40
The Beast ! More than 200N.m of torque. This 1000W middle drive motor BBSHD here in M615 version is a war machine, a Tank ! 6Kg butallows you to climb the trees. It will be perfect for heavy riders over 110Kg, extrem...
Interrupteur ON-OFF Interrupteur ON-OFF

Double positions siwtches handset

€14.00 (tax incl.)
Double positions siwtches handset for handlebar installation or 22mm tube. Delivered with a 2 ways JST connector and a 1100mm cable length
TORQUE ARM Base 4

TORQUE ARM Base 4

€12.00 (tax incl.)
In 6.20 mm thick stainless steel To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame. Plan "Base 4 M12" Plan "Base 4 M14"
Sonde de vitesse

Speed sensor for cycle analyst

€16.00 (tax incl.)
The speed sensor for Cycle Analyst is the ideal accessory to accurately measure your actual speed and distance traveled on your electric bike. Connected directly to your on-board computer, this sensor works with a...
coupure frein câble connecteur jst coupure frein câble connecteur jst

Cable brake cut-off for controller 25A and 35A OZO

€15.00 (tax incl.)
This brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles It is quick to install on the brake handle or caliper....
Engine kit Crankset Bafang BBS02 B 500W Engine kit Crankset Bafang BBS02 B 500W
Limited special offer

Bafang 36V BBS02 500W mid drive motor without battery

€680.00 (tax incl.) €772.40
120N.m of torque for this 36V 500W middle drive system for general use. It's appreciated by riders over 85Kg. The Bafang BBS02 36V M315 central Motor Kit is offered here in medium transmission for road and VTC.
Interrupteur 2 positions rond vert ON-OFF pour vélo Interrupteur 2 positions rond vert ON-OFF pour vélo

Thumb throttle with switch for ebikes

€29.00 (tax incl.)
his accelerator for electric bicycles is activated with the thumb. Cable length: 1m This model is versatile, meaning you can install it on the right or left side of your handlebar. This set includes a waterproof...
10 kw Electric retrofit motor watercooling

6kW to 9kW liquid-cooled brushless mid-drive electric motor

€999.00 (tax incl.)
Special retrofit for boats, motorcycles, go-karts, ATVs, or sailboats, this IPM brushless electric motor with a central rotor is designed to deliver a power output of 6kW to 10kW depending on the supply voltage of...
TORQUE ARM Base 3

TORQUE ARM Base 3

€12.00 (tax incl.)
In 6.20 mm thick stainless steel To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on the frame. Plan "Base 3 M12"
Support potence pour CA Support potence pour CA

Support bracket for CA

€16.00 (tax incl.)
The CA (Cycle Analyst) bracket is the ideal accessory to install your on-board computer directly in the center of your cockpit. By attaching the Cycle Analyst to the stem, you free up space on your handlebars while...
Capteur pédalier intégré pour contrôleur 15A et 22A Capteur pédalier intégré pour contrôleur 15A et 22A

JST pedal box sensor for OZO controller

€20.00 (tax incl.)
Pedal sensor in housing for OZO controller 25A and 35A. For cases with external bearings such as Shimano hollowtech, choose the "transmission side". Very simple installation. 3-way JST male connector. Installation...
coupure frein câble connecteur jst coupure frein câble connecteur jst

Cable brake cut-off for controller 15A-22A OZO

€20.00 (tax incl.)
This 33cm brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles It is quick to install on the brake handle or caliper....
BBS02 48V 750W - 1200W mid-drive motor BBS02 48V 750W - 1200W mid-drive motor
Limited special offer

Motor Kit Pedal 750W City-VTC-Road BBS02 without battery

€730.00 (tax incl.) €822.40
160N.m of torque for this 750W central motor which will be ideal for riders over 100Kg to do everything that you can imagine on your electric bike regardless of terrain and elevation.
KELLY battery cable with 150A Anderson connector

KELLY battery cable with 150A Anderson connector

€36.00 (tax incl.)
Standard cable with special lugs for screw terminal block of KELLY controllers. Standard length: 35cm / Optional extension possible: 50cm, 1m,  Cable section: 10AWG / 5mm2 + after wired contact to switch on the...
Interrupteur 2 positions rond vert ON-OFF pour vélo Interrupteur 2 positions rond vert ON-OFF pour vélo

Thumb throttle with switch for ebikes

€29.00 (tax incl.)
his accelerator for electric bicycles is activated with the thumb. Cable length: 1m This model is versatile, meaning you can install it on the right or left side of your handlebar. This set includes a waterproof...
Adaptateur éclairage Anderson vers 2 JULET Mâle Z209AG Adaptateur éclairage Anderson vers 2 JULET Mâle Z209AG

ANDERSON to JULET Z209AG adapter

€25.00 (tax incl.)
ANDERSON to JULET Z209AG adapter. Allows to install ebikes lights by connecting in series between batetry and controller
10 kw Electric retrofit motor watercooling 10 kw Electric retrofit motor watercooling

Central electric motor 10kW brushless liquid cooling

€1,290.00 (tax incl.)
Special retrofit for boats, motorcycles, go-karts, ATVs, or sailboats, this IPM brushless electric motor with a central rotor is designed to deliver a power output of 6kW to 10kW depending on the supply voltage of...
Jante MACH1 610 Jante MACH1 610

MACH1 ROAD RUNNER Rim

€29.90 (tax incl.)
The MACH1 ROAD RUNNER rim is a semi-profiled rim with eyelets, ideal for thin tyres and compatible with wide tyres for more comfort. In 700.
Base 1 Base 1
Limited special offer

Pack Torque arm to screw M5 / M6

€19.00 (tax incl.) €21.50
The Torque Arm allows to limit the stress on the bike frame, at the level of the wheel fixing beaks, to avoid any deformation. It is highly recommended for kits over 400W.
Moteur Moteur

Agriculture electric wheel 500W universal brushless motor

€390.00 (tax incl.)
This 500W-1000W electric brushless universal motor offers the ability to choose different wheel diameters and tire widths with its removable aluminum machine casted rim flanges. The ability to remove the rims makes...
Cable de programmation

Programming cable for cycle analyst

€20.00 (tax incl.)
This cable allows to update your cycle analyst with the last software version and also to read and set all datas on your computer.
Poignée de frein à contact pour Bafang BBS01 BBS02 BBSHD Poignée de frein à contact pour Bafang BBS01 BBS02 BBSHD

Bafang brake ebrakes

€20.00 (tax incl.)
Bafang ebrake for BBS01 BBS02 BBSHD Maxdrive Can also be plugged on any ebikes with Julet waterproof connector 3 pins.
Base hexagonale

hexagonal base

€21.00 (tax incl.)
This hexagonal base offers angular freedom that allows it to adapt to all frame geometries. To check the installation of the torque arm on your bike, you can print the plan below, cut out the part and position it on...
3-Way JST extension cable 3-Way JST extension cable

3-Way JST extension cable

€8.00 (tax incl.)
This extension cable has a 3-way JST connector for pedal sensor or accelerator. With switch 3-Position. Available in 3 lengths : 30 cm 50 cm 100 cm
Moteur 500W 1000W brushless central inner rotor Moteur 500W 1000W brushless central inner rotor

Moteur 500W 1000W brushless central inner rotor

€199.00 (tax incl.)
Central brushless BLDC motor that can deliver 500W under 24V, 750W under 36V and 1000W unde 48V. Can drive any rotating tools or small kids electric  motorcycle or scooter. Max speed is 3500 Tr/min under 48V Max...
KELLY motor cable with XT150 connector

KELLY motor cable with XT150 connector

€35.00 (tax incl.)
Standard motor cable with special lugs for screw terminal block of KELLY controllers. Standard length: 35cm / Optional extension possible: 45cm, 1,1m. Cable section: 10AWG / 5mm2 + after wired contact to switch on the...

OZO offers a wide range of components for electric bicycles for the optimization or repair of electric bicycles with wheel motor or pedal motor.

Read moreShow less
Close
Click for more products.
No products were found.

Settings

Click for more products.
No products were found.

Menu

Please sign in first.

Sign in