€690.00
(tax incl.)
Brushless BLDC 6kW motor to convert any bike 125cc or 250cc into electric. Can also powered electric boat or karting
9,1kg
Filters
Composant ki
€25.00
(tax incl.)
Standard cable with special lugs for screw terminal block of KELLY controllers.
Standard length: 35cm / Optional extension possible: 50cm, 1m
Cable section: 10AWG / 5mm2
+ after wired contact to switch on the...
€12.00
(tax incl.)
Multifunction two-position switch.
It can be used as a forward/reverse switch, ON/OFF for your lighting, or for your OZO controller.
Supplied with a 2-way JST connector.
€15.00
(tax incl.)
Support for potentiometer to screw on the back of the V2 or V3 analyst cycle
€25.00
(tax incl.)
This half handle accelerator is compatible with all our kits.
The two-position switch can be used to turn off the engine if it is wired to the "brake off" input of the controller or to power your lighting.
€10.00
(tax incl.)
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
"Base 1 M12" plan
"Base 1 M14" plan
€20.00
(tax incl.)
Contact brake handle compatible with the 22A OZO controller
You can buy a right handle or a left or the pair.
Two colors available: Gray or black.
€25.00
(tax incl.)
Standard motor cable with special lugs for screw terminal block of KELLY controllers.
Standard length: 35cm / Optional extension possible: 45cm, 1,1m.
Cable section: 10AWG / 5mm2 + after wired contact to switch on...
€20.00
(tax incl.)
Motor cable extender 45cm and 1m
Extension for motor cable with 3x 2.00mm2 cables for the phases and 5x 0.22mm2 cables for the HALL sensors.
The extensions are supplied with Anderson PP30 connectors for the phases...
€14.00
(tax incl.)
Double positions siwtches handset for handlebar installation or 22mm tube.
Delivered with a 2 ways JST connector and a 1100mm cable length
€699.00
(tax incl.)
This Brushless electric motor PMSM (Permanent Magnet Inner Rotor Motor) with Hall effect sensors is designed to deliver a power of 5000W at 48V, generating a torque of 130 N.m and a maximum rotational speed of 3500...
€12.00
(tax incl.)
In 6.20 mm thick stainless steel
To check the installation of the torque arm on your bike, you can print the plans below, cut out the part and position it on the frame.
Plan "Base 4 M12"
Plan "Base 4 M14"
€20.00
(tax incl.)
This 33cm brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles
It is quick to install on the brake handle or caliper....
€20.00
(tax incl.)
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way...
€79.00
(tax incl.)
OZO offers you to choose from three models of displays with Bafang protocol UART 5.2 and 5.8 with cylindric green 5 pins female connector.
Compatible with all bbs series central motor from Bafang and some OZO hub...
OZO offers a wide range of components for electric bicycles for the optimization or repair of electric bicycles with wheel motor or pedal motor.
