€25.00
(tax incl.)
Magnet ring specially designed for carbon frame road bicycle with compact crankset.
Chargement des images...
Pedal sensor for generic OZO controller
Pedal sensor compatible with the generic 250W controller for the repair of electric bikes.
2 models available: Integrated 12 magnets or V7 6 magnets
The V7 comes with a 6-magnet magnetic washer.
Cable length of 60 cm on the V7
€19.00
(tax incl.)
Reference:
000046
You may also like
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€20.00
(tax incl.)
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way...
€10.00
(tax incl.)
This bracket allows the installation of the bottom bracket sensor on the frame under the crankset, when it is not possible to install the bottom bracket sensor on the vertical frame tube.
The pedal sensor’s probe is...
€20.00
(tax incl.)
Pedal sensor in housing for OZO controller 25A and 35A.
For cases with external bearings such as Shimano hollowtech, choose the "transmission side".
Very simple installation.
3-way JST male connector.
Installation...
€20.00
(tax incl.)
Pedal sensor for 15A and 22A OZO controllers to be installed on the vertical frame tube
Supplied with the 12-magnet half discs and the probe.
3-way Julet waterproof connector.
Cable length: 120 mm.
End to end...
€39.00
(tax incl.)
Pas sensor for Cycle analyst V3 CA V3. Can be installed on left side or right side of your bike.
Customers who bought this product also bought:
€24.90
(tax incl.)
Capacity indicator for Lead-acid, Li-ION or LiFePO4 battery. Input voltages from 10 to 100V. Displays the remaining battery percentage, temperature and voltage.
€34.90
(tax incl.)
Front led light 100 Lumens for electric bike. Fork bracket included.
Waterproof Julet 2 pins connector Z209.
Ebikes and speed bikes certified.
€19.00
(tax incl.)
The pedal sensor is a rotation sensor. You are required to pedal for assistance and you cannot precisely dose the desired level of assistance since this level is determined by a law of assistance specific to the...
€99.00
(tax incl.)
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
€16.90
(tax incl.)
Available in 30cm / 50 cm / 70cm / 1m / 1m20 / 1m50 / 2m
€30.00
(tax incl.)
Universal shunt 1mOhm for V2 and V3 analyst cycles. You can use the analyst cycle on any controller, solar panel, or charger. Supports a direct current of 50A and a max current of 100A
€6.50
(tax incl.)
Julet Z309AG waterproof connector 2m length cable
Leave a review